|
|
DRIVER INSPECTION |
|
|
|
Helmet: Motorcycle (DOT approved) |
|
|
Eye Protection (Full face shield
okay) |
|
|
Gloves (Optional for enclosed
vehicles) |
|
|
Long Pants & shirt |
|
|
Shoes |
|
|
Signed liability release |
|
|
Driver’s license |
|
|
Driver’s weight + ballast =180# Min. |
|
|
BASIC VEHICLE INSPECTION |
|
|
Vehicle dimensions (Max 12’ L x 4’
W) |
|
|
Vehicle number 6" Min. (Both Sides) |
|
|
Ground clearance >tire sidewall
height |
|
|
Pneumatic Tire (Inflatable) |
|
|
Tire wear and & condition within
limits |
|
ELECTRICAL INSPECTION |
|
|
Good visibility and field of vision |
|
Battery type approved (See back
sheet) |
|
|
Rear view mirrors present &
effective |
|
Battery weight does not exceed 67#
|
|
|
Good structural integrity |
|
Battery voltage = |
|
|
Fasteners & fittings, secure
&adequate |
|
Battery enclosed & mounted securely |
|
|
Design gives side protection for
driver |
|
Battery Clear and tight |
|
|
Body stops driver contact w/another
car |
|
Battery connector clear of driver |
|
|
No exposed sharp edges / components |
|
Battery caps secure |
|
|
5 pt. Seat belt harness system |
|
Cable gauge (#4 Min=12V,#6Min=24V) |
|
|
Roll Bar height Check
³
2" above helmet |
|
Wiring neat, secure, and well
insulated |
|
|
Roll bar braced at bar top and to
frame |
|
System is ungrounded |
|
|
Roll bar padding (Min. ½" thick) |
|
Circuit breaker or fuse inside
vehicle |
|
|
Canopy securely attached (if
applicable) |
|
Proper rating for above item |
|
|
Min. Axle dia. 3/8" (supported both
ends) |
|
Outside Kill switch |
|
|
Cantilevered Axle dia. > ½" |
|
Proper rating for above item |
|
|
Cantilevered Axle nuts secured with
wire or pins |
|
4" Red triangle around outside kill
switch |
|
|
Steering /suspension=strong,
adequate |
|
|
|
|
Chain Guard (if needed) |
|
|
|
|
Motor, controller & drive mounts
secure |
|
|
|
|
Automatic throttle shutoff |
|
|
|
|
VISION TEST (driver must be able to
discern to number of fingers behind vehicle at a distance of 10
feet) |
|
SCHOOL NAME |
|
|
SAFETY BELT TEST (belts must be able
to support vehicles weight) |
|
VEHICLE NUMBER |
|
|
EXIT TEST (driver must exit vehicle
with canopy in place in 20 seconds or less) |
|
DRIVER’S NAME |
|
|
BRAKE TEST (Two wheels on same axle
must lock with one control) |
|
Inspector’s signature |
